Logo

B2481 Engine Code Repair

Meaning of B2481 engine trouble code is a kind of body trouble code and when the check engine light comes B2481 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

B2481 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for B2481 code is occuring now you should check B2481 repair processes.
Now don't ask yourself; What should you do with B2481 code ?
The solution is here :

B2481 Possible Solution:

B2481 Engine

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

B2481 Code Meaning :

B
OBD-II Diagnostic Body (B) Trouble Code For Engine

2
Fuel And Air Metering (Injector Circuit Malfunctions Only)

4
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent

8
Cylinder 10 Contribution/balance Fault

1
Shift Solenoid E Performance or Stuck Off

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

B2481 OBD-II Diagnostic Body (B) Trouble Code Description

B2481 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Main reason For B2481 Code

The reason of B2481 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.

B2481 DTCs may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.